ICON A5 MM : Propulsion : Engine : Cooling System : Maintenance Instructions : Coolant Overflow Bottle Removal
Coolant Overflow Bottle Removal
100114-00
Use the following procedure to remove the coolant overflow bottle.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
13—Propulsion
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the engine top cowling. (Remove Engine Cowlings)
2. Cut the cable tie and disconnect the black silicone hose from the bottom nipple on the overflow bottle. Catch the coolant in a suitable container as it drains from the bottle and hose.
3. Remove the cap from the overflow bottle, cut the two cable ties securing the bottle to the mount bracket and remove the bottle.
4. Carefully inspect the ICA011500 overflow bottle bracket for cracks, paying special attention to the inside corners of cutouts where stress is highest. If damage is found, remove the bracket by removing the two M8 and on M10 screws that attach it to the gearbox.
5. Inspect the yellow Tygon and black silicon hoses that attach to the bottle. If the hoses are stiff, cracked or otherwise damaged, remove them by cutting the securing cable ties and hose clamps.
Verification Method
Procedure is complete steps have been finished. If coolant overflow bottle needs replaced see installation procedure. (Coolant Overflow Bottle Installation)