ICON A5 MM : Wing : Wing General Maintenance : Install Left Wing
Install Left Wing
100633-00
Use the following procedure to install the left wing onto the airplane.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
A second person and a ladder are needed to hold the wing.
Parts Required
2X—wing U-joint retaining ring—P/N 98410A110
Aircraft System and Number
14—Wing
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Unlock wing locking mechanism by pressing latch pawl on the wing lock switch, and then simultaneously pull the wing handle lock down all the way to unlock both locking pins.
2. Lift the wing in place and align the rotating hinge U-joint connector to the U-joint pins mounting holes. Verify the face of the U-joint that is further from the wing fold tube (larger gap) is oriented down. If this is not in the proper orientation, the wing will not seat into center wing.
3. Install upper and lower U-joint pins with clips on inside diameter of U-joint.
4. Slide the wing inward and leave about a foot separation, and rest the wing tip securely on a ladder.
5. Secure U-joint with retaining rings.
CAUTION: 
Utilize new retaining rings every time reassembly takes place.
6. Locate the avionics tubes, electrical harness for lights, and the fuel vent tube inside the hinge.
7. Connect the electrical connector from the protruding pigtail.
8. Connect the AOA tubes high pressure tube and low pressure tube on one side of the push-on tube connectors.
CAUTION: 
Be sure to connect the high pressure tube and low pressure in appropriate connectors for the avionics to function properly.
9. Connect the fuel vent tube on one side of the push-on tube connector.
10. Align the mid-wing pin to the mid-wing pin bushing.
11. Slide the wing inward ensuring the aileron roll bell crank and the roll clamshell align. Also ensure flap pin and flap pin socket aligns.
12. Slide until flush.
13. Rotate latch lever upward and listen for the snap sound of the latch pawl. Pull gently downward to ensure lever is securely locked.
Verification Method
Carefully inspect wing fold joint to ensure proper latching and security. Power on master switch and check annunciator panel to confirm no light indicating to secure wing/tail (horizontal tail tips must also be installed).