ICON A5 MM : Recommended Inspections : General Inspection Tasks : Cockpit Panels Removal and Installation : Headliner Removal
Headliner Removal
100253-00
Use this procedure to remove the headliner.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
NA
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the four light control knobs from the overhead console by pulling each down and off their D-shafts.
2. Remove the overhead console bezel by pulling down on its forward edge, disengaging two spring clips. Disengage the two indexing tabs at the aft edge of the bezel, then remove the bezel.
3. Pull the right and left sides of the headliner inward, and the entire headliner forward and down to separate the hook and loop fastening and gain enough room to access the back of the headset hangers.
4. Disconnect the two headset hanger light connectors.
5. Remove the headliner.
Verification Method
This procedure is complete when the headliner has been fully removed from the overhead console bracket.